Table of Contents

Convert PDF to pictures

Seldom printers fail to print a PDF file, a possible solution is to convert the file to a sequence of pictures; basically this means to do the whole process that decides where the inks should go in your computer; before sending the result to the printer.

Ghostscript does most of the hard work creating the pictures, however it does not apply any kind of smoothing to the curves so when creating a picture in the printing resolution (usually 300 DPI) the result will be poor.

To workaround this problem we use a trick similar to videogames antialiasing. We create the picture 4 times larger and we resize it later to the correct size applying smoothing algorithms.

Finally we losslessy put all the pictures in a new PDF. The resulting PDF will have no text, no fonts or anything a part of pictures. So it loses much of its convenience and the resulting file will be much larger, however printers will not fail to print it.

Software used:

Step 1, create the large image files:

$ gs -sDEVICE=pngalpha -o output-%04d.png -r1200 input.pdf

Please note that 1200 is four times the wanted resolution, we want to print to 300DPI.

Step 2, resize the resulting pictures to have antialiasing and remove transparency information:

$ for f in output-*  ;do convert "$f" -background white -alpha remove -alpha off -resize '25%' s"$f"  ;done

Step 3, rebuild an easy to print PDF:

$ img2pdf --pagesize a4 --border 0 --output easy2print_output.pdf soutput-*png

Excessive memory usage

It is possible to use greater resolutions to print for example with 600DPI, just use -r2400. But the convert step may require too much memory to resize the output .png files. It is the case, it is possible to limit the amount of memory using environment variables:

MAGICK_TEMPORARY_PATH=. MAGICK_AREA_LIMIT=1024mb  convert ...

convert will store its temporary files in the current directory and avoid using more than 1Gb of memory. The process might be slower, but it will end correctly.

Here is the list of environment variables that ImageMagick understands.

Change paper size

img2pdf creates a .pdf file with the requested page size. But if the original .pdf was in another format the pages might have weird borders as the result will be squeezed, but not deformed. To print a letter size .pdf in A4 for example will result in very tall top and bottom borders; this happens because the letter paper size is wider and shorter, when squeezed in the A4 the horizontal borders will be almost the same (because the picture is just a bit smaller), but the vertical ones will be much taller.

It is worth a try to trim the pictures to have the new paper size. To do so you need to know the correct size of the picture and convert. For example, if you want to print 300DPI, the picture size will be the paper size in inches times 300.

The command, for a 300DPI A4 will be:

$ convert input.png -gravity Center -crop 2481x3507+0+0 +repage output.png 

It is also possible to add -gravity Center -crop 2481×3507+0+0 +repage directly in Step two just before the output filename.